System Detected Improper Connection Of Parking Brake Lead
System Detected Improper Connection Of Parking Brake Lead. Please see operation manual for more information regarding safe Test the connection by activating your parking brake.
Connect the black wire to the either the factory ground wire, the pioneers black ground wire or its own chassis ground. Light green used to detect the on/off status of the parking brake. Thus, i assumed that the red.
Connect One End Of The Wire To A Positive (+) Terminal On Your Battery And The Other End To Any Exposed Metal Surface On Your Car (Such As A Bare Screw Or Bolt).
You can also share a connection with your new radio. As this was happening, the red brake light was flashing on and off.when the parking brake is released, chassis air is diverted to the top of the entry door and forces a plastic wedge into place to help eliminate wind noise. Power supply side parking brake switch ground side note the position of the speed detection circuit
This Unlocks Most Features On A Double.
High quality at an affordable price expertly made from premium materials. Up to $8 cash back when this warning comes up it is typically caused by a bad parking brake switch. Hummer h2 2007, front brake fluid level sensor connector by skp®.
What Is Parking Brake Lead?
The instructions in the pioneer manual say that the light green wire should be connected to the power side of the parking brake switch, however, the switch in the picture only has one wire coming out of it (the red and black one). Connect blue wire from microbypass to the pioneers blue w/white wire (amp turn on). How to install the pioneer microbypass switch.
Thus, I Assumed That The Red.
Not the solid blue wire. If it is staying on then the switch is more than likely bad. Light green wire which is the parking brake wire that comes with the pioneer harness.
This Lead Must Be Connected To The Power Supply Side Of The Parking Brake Switch.
Please see operation manual for more information regarding safe The parking brake cable is the cable that many vehicle’s use to engage their parking brakes. Used to detect the on/off status of the parking brake.
Post a Comment for "System Detected Improper Connection Of Parking Brake Lead"